Own Rorty. Website, CAD, plans, IP, inventory & equipment. Find Out More

Setting Up an Hydraulic Bike Clutch Pedal

When using the stock bike slave cylinder with a Girling type master cylinder (normally Ø.625″), it is possible to push the pedal too far, causing damage to the clutch.

Fitting a pedal stop (applies to a cable operated clutch too) is an obvious solution and ascertaining where the stop should be is fairly simple.

Adjusting the pedal stop should be carried out with the rear of the buggy securely raised on stands. While idling in first gear, lightly drag the brakes and push the clutch in slowly. The point where the wheels stop rotating is the position where the clutch pedal stop should be – plus a quarter turn. Much further and damage could occur.

More Posts

Paddle Shift or Shift Lever?

April 23, 2021
Read More

To Diff Or Not To Diff

April 8, 2020
Read More

Stuck At Home? Get 25% Off Now!

March 23, 2020
Read More

Rorty uses cookies to ensure you get the best experience on our website. Click here to read more.